Magnetic field hysteresis of critical currents in Bi(2223)/Ag tapes and a way to overcome it

Experiments showing hysteresis of critical currents versus the external magnetic field I_c(B_e) were performed with two multifilamentary Bi(2223)/Ag tapes. The I_c(B_e) hysteresis is observable in the transversal as well as in the longitudinal orientation of the long axis of the tape with respect to the magnetic field. Based on the idea that the hysteresis is the effect of trapped flux in a network of well-connected current paths, a way to overcome this effect has been proposed and experimentally verified. The induced frozen-in screening currents are split into several parallel current patterns by cycling the external magnetic field around the adjusted value. Using the proposed method, the ‘neutral’ I_c(B_e) characteristics have been found. Approximate calculations of the penetration depth of the trapped flux show that the network of well-connected current paths could be formed by several disk-shaped grains (≈ Φ8 × 0.4 μ) stacked into more or less axially ordered (quasi cylindrical) colonies of average dimensions estimated to ≈ Φ8 × 4 μm.     

Effects of shear flow on long-ranged correlations,spinodal demixing kinetics,and the location of the critical point and cloud point

A derivation of an expression for the shear rate-dependent Ornstein Zernike structure factor is discussed, together with the resulting anomalous behavior of the turbidity. The predicted scaling behavior of the turbidity, comprising the effect of both temperature and shear rate, is in good agreement with experiments on binary fluids. Then initial spinodal decomposition is discussed, and an explicit expression for the time- and shear rate-dependent effective diffusion coefficient is derived, which shows all the typical characteristics of anisotropic light scattering patterns that are observed experimentally for binary fluids. Next it is shown that the spinodal is shifted linearly with the (bare) Peclet number for not too large Peclet numbers, whereas the cloud point is singularly displaced into the unstable region due to a shear now. This is in agreement with an experiment on a two-polymer/solvent mixture and binary fluid mixtures. It is argued that light scattering is useless to determine the location of the spinodal of a sheared system.Paper presented at the Twelfth Symposium on Thermophysical Properties, June 19–24, 1994, Boulder, Colorado, U.S.A.     

小麦、玉米控制灌溉技术研究

198 6～ 1998年 ,在山东省的 3个灌溉试验站 ,对冬小麦、秋玉米进行了控制灌溉试验 ,对农作物的多个生育阶段 ,按高产的要求 ,分别给予适时、适量的灌溉水 ,来控制作物不同生长期的根层土壤含水量 ,从而控制作物不同生长期根系对水分的吸收 ,培植农作物的“丰产群体结构”和与之相适应的“高产理想株型” ,适当降低无效的蒸腾量 ,使农作物能在高产的基础上再增产 .该项控制灌溉技术获得了明显的节水、增产效果 ,灌溉水的生产效率超过了 10kg/m3,产量超过了 8t/hm2 .     

白丰梯级水库实用电力优化调度图的研制——变动目标水位控制法的研究

在分步设计及大量计算的基础上，提出了一套考虑因素相对全面、指导 性强、易于操作的梯级水库电力实用优化调度图。该调度图继承了传统时历法调度图直观、 简明的优点，又具有其特有的优化功能。该方法以汛末蓄满水库为标准，确定典型来水过程 的预调度线和初始目标；以获得梯级电站最大长期调峰收益为目标，以变动目标水位控制为 核心，开发出调度图长系列操作通用程序模块，并以此模块作为寻优计算的手段。提出了水 库长期运行与短期实时调度有机结合，以及模拟计算、水位偏差最优反馈、来水预报、目标 水位寻优等多种实用处理技术。     

燃气空调的优势及对燃气和电力调峰的意义

分析了天然气季节性调峰的各种手段，指出燃气空调的技术经济优势，以及发展燃气空调对于电力和燃气系统季节性调峰的作用。     

Rhizobium trifolii capsular polysaccharide: a novel biopolymer with striking physical properties

The physical properties of the capsular polysaccharide of Rhizobium Trifolii (CPS) were investigated. Viscosity measurements provided information about the hydrodynamic volume of single coils, the perturbation of solvent flow and the shear-thinning behaviour of concentrated solutions. Changes in chain geometry and the development of an intermolecular network as a function of temperature were monitored using the techniques of optical rotation and dynamic oscillation. Finally, analysis of calorimetric thermograms elucidated the type of interactions between CPS and the bacterial levan. Overall, the Rhizobium polysaccharide was found to form thermally-reversible gels at an extremely low 'minimum critical gelling concentration' (c_o∼ 0.35gl^-1). At temperatures above the gel melting point (∼ 48°C), however, the compact polymer coils entangled at comparatively high concentrations (about 60 times higher than c_o). In the presence of a highly branched levan, the thermal stability of ordered CPS structures increased as a consequence of thermodynamic incompatibility between the two polymers.     

Fabrication and characteristics of tapes and test magnets made from Ag-Clad Bi-2223 superconductors

Pb_0.4Bi_1.8Sr₂Ca_2.2Cu₃O_x (Bi-2223) precursor powder was prepared by a solid-state reaction of carbonates and oxides of lead, bismuth, strontium, calcium, and copper, and the powder was then used to fabricate silver-clad tapes by the powder-in-tube technique. Transport critical current density (J_c) values>4×10⁴ A/cm² at 77K and 2×10⁵ A/cm² at 4.2 and 27K have been achieved in short tape samples. Long lengths of tape were tested by winding them into pancake coils. Recently, we fabricated a test magnet by stacking ten pancake coils, each containing three 16m lengths of rolled tape, and tested it at 4.2, 27 and 77K. A maximum generated field of 2.6 T was measured in zero applied field at 4.2K and the test magnet generated significant self-field in background fields up to 20 T. The results are discussed in this paper.     

Dependence of critical current density on microstructure and processing of high-Tc superconductors

Microstructural origins for reduced weak-link behavior in high-J_c melt-processed YBCO, spray pyrolyzed thick films of Tl-1223, metallic precursor Y-124 polycrystalline powder-in-tube (PIT) wires and PIT Bi-2212/2223 are discussed. Since the materials studied are the highest J_c, polycrystalline, high-T_c superconductors fabricated worldwide, the results provide important guidelines for further improvements in superconducting properties, thereby enabling practical applications of these materials. It is found that strongly linked current flow within domains of melt-processed 123 occurs effectively through a single crystal path. In c-axis oriented, polycrystalline Tl-1223 thick films, local in-plane texture has been found to play a crucial role in the reduced weak-link behavior. Formation of “colonies” of grains with a common c-axis and modest in-plane misorientation was observed. Furthermore, a colony boundary in general has a varying misorientation along the boundary. Large regions comprised primarily of low angle boundaries were observed. Percolative transport through a network of such small angle boundaries appears to provide the nonweak-linked current path. Although powder-in-tube BSCCO 2212 and 2223 also appear to have a “colony” microstructure, there are some important differences. Colonies in BSCCO consist of stacks of grains with similar c-axis orientation in contrast to colonies in Tl-1223 films where few grains are stacked on top of one another. Furthermore, most grains within a colony in BSCCO have the same lateral dimensions as that of the colony, resulting largely largely in “twist” boundaries. Further microstructural characterization of high-J_c PIT 2212 and 2223 is currently underway. In the case of Y-124 wires, weak macroscopic in-plane texture is found. Additional measurements are underway to determine if a sharper, local in-plane texture also exists. It is found that in three of the four types of superconductors studied, reduced weak-link behavior can be ascribed to some degree of biaxial alignment between grains, either on a “local” or a “global” scale.     

家电产品常用板材的选用

本文首先介绍国内和日本、德国、俄罗斯等国冷轧薄钢板及镀锌薄钢板的牌号、标记识别及生产地及与我国家标准薄钢板牌号的相互之间的关系，并比较具体地介绍冷轧板的实效性、镀锌薄钢板的锌层特性等诸多方面的状况。从而帮助我们在设计、制造家电产品中，比较正确地选择合适的板材。     

2006年上半年我国钢管行业发展基本情况及下半年市场预测

通过对2006年1～6月份我国钢材和钢管产量情况、钢管进出口情况、钢管进出口主要品种及平均价格等数据的分析,指出由于国际、国内两大钢管市场发展形势较好,拉动了我国钢管产销两旺,从而使我国钢管市场的发展态势具有两大特点:①国内市场需求由低迷转而旺盛,价格呈恢复性上涨;②国际市场需求持续旺盛,进一步刺激钢管企业加大出口力度,出口再创新高.根据上半年钢管市场的发展形势,预测了2006年下半年钢管市场的发展趋势,同时指出,我国钢管企业应抓住目前的发展机遇,不断提高钢管产品的附加值和技术含量,提高在国际市场的竞争力,加快我国由钢管大国向钢管强国的转变速度.